Fig. 9.1
Soft pillow and arm board for patient positioning
Fig. 9.2
External retractor for maintaining the working space
Fig. 9.3
Devices for developing the working space
For the robotic procedure, a da Vinci S or Si system (Intuitive, Inc., Sunnyvale, CA, USA) can be used. Three robotic instruments (5-mm Maryland dissector, 8-mm ProGrasp forceps, and 5-mm Harmonic curved shears) and a dual-channel camera (30° down) are needed (Table 9.1). Small rolled-up gauzes are used for control of bleeding.
Table 9.1
Special equipment for the robot-assisted transaxillary thyroidectomy
Patient positioning (Fig. 9.1) |
Soft pillow |
Arm board |
Development of working space (Fig. 9.2) |
Electrocautery with short, regular, and long tip |
Vascular DeBakey |
Army-navy retractor × 2 |
Right-angled retractors × 2 |
Breast lighted retractor × 2 |
Maintenance of working space (Fig. 9.3) |
Chung’s retractor |
Table mount and suspension device (BioRobotics, Seoul, Korea, or Marina Medical, Sunrise, FL) |
Robotic procedure |
5-mm Maryland dissector |
8-mm ProGrasp forceps |
5-mm Harmonic curved shears |
Dual-channel 30° endoscope (used in the rotated down position) |
Assistant instruments |
Ethicon Endopath graspers and forceps |
Ethicon Endopath suction irrigator |
Miscellaneous |
Small rolled-up gauzes |
Surgical Indications
Based on the feasibility and safety of endoscopic transaxillary thyroidectomy for low-risk papillary thyroid microcarcinomas, the initial eligibility criteria for RAT were limited to well-differentiated thyroid carcinomas with a tumor size of ≤2 cm (without extrathyroidal tumor extension) or to benign tumors with a size of ≤5 cm. At that time, due to the possibility of injuring critical structures (trachea, esophagus, or recurrent laryngeal nerve [RLN]) during the procedure, lesions located deep in the thyroid bed, especially those adjacent to the tracheoesophageal groove, were considered ineligible. With greater experience the indications have expanded and now include advanced cancer cases, such as those with definite adjacent muscle invasion, RLN invasion, and lateral neck node metastasis.
Currently, the eligibility criteria for RAT are as follows: (1) benign tumor or follicular neoplasm with a size of ≤5 cm, (2) mild- to moderate-size Graves’ goiters, and (3) well-differentiated thyroid carcinomas with a primary tumor size of ≤4 cm and minimal invasion by the primary tumor into the anterior thyroid capsule and strap muscles. The contraindications for RAT include (1) definite tumor invasion into an adjacent organ (RLN, esophagus, major vessels, or trachea), (2) metastasis to multiple lymph nodes in multiple levels of the lateral neck, and (3) perinodal infiltration around a metastatic lymph node. Prior to surgery, all patients should be evaluated by an ultrasonography-guided fine needle aspiration biopsy and the clinical stage should be checked by a staging neck ultrasonography or computed tomography scan.
Procedural Details
Patient Positioning
The patient is placed in the supine position with neck extension by inserting a soft pillow under the shoulders. The lesion-side arm is raised to shorten the distance between the axillary incision and the target area. To avoid brachial plexus paralysis, the arm is extended naturally within the range of shoulder motion and should not be fixed by force. A modified arm position or a laterally abducted position is helpful with a stiff shoulder.
Creating Working Space
The neck region is relatively narrow and encases many vital structures without a natural body cavity, therefore, making an artificial space for accessing the thyroid gland is demanding. Additionally, sufficient working space is essential for optimizing the use of the robot.
The working space consists of the outer and inner spaces. The outer space is the channel for approaching the target area and is bound by a subcutaneous skin flap and the pectoralis major muscle. The robotic dissection is performed in the inner space, which is surrounded by strap muscles and the sternal head of sternocleidomastoid (SCM) muscle ventrally and by the trachea, major blood vessels, and the clavicular head of SCM muscle dorsally (Fig. 9.4a).
Fig. 9.4
(a) The working space of the robotic thyroidectomy consists of the outer and the inner spaces. The outer space is bound by a subcutaneous skin flap (a) and the pectoralis major muscle (b). The inner space is surrounded by strap muscles (c) and the sternal head of sternocleidomastoid (SCM) muscle (d) ventrally and by the trachea, major vessels, and the clavicular head of SCM muscle (e) dorsally. (b) The reference landmarks of robotic thyroidectomy: (a) the sternal notch, (b) a transverse line from the sternal notch laterally to the axilla (inferior limit of the incision), (c) the upper limit of the lesion side of the thyroid gland, (d) 70–80° oblique line from the thyroid upper pole laterally to the axilla (superior limit of the incision), and (e) the medial border of the ipsilateral SCM muscles. Pm platysma muscle, STm sternothyroid muscle, SHm sternohyoid muscle, SN sternal notch, CCA common arotid artery, IJV internal jugular vein, CL clavicle, EJV external jugular vein, PMm pectoralis major uscle, Omo omohyoid muscle, Tm trapezius muscle, SCM-s sternal head of SCM muscles, SCM-c clavicular head of SCM muscles
The reference landmarks are (1) the sternal notch, (2) a transverse line from the sternal notch laterally to the axilla (inferior limit of the incision), (3) the upper limit of the lesion side of the thyroid gland, (4) a 70–80° oblique line from the upper pole of the thyroid to the axilla (superior limit of the incision), and (5) the medial border of the ipsilateral SCM muscle (Fig. 9.4b). A 5- to 6-cm vertical skin incision is made in the axillary area. The precise location of this incision (in a cephalad-caudad vector) should be based on the height of the upper limit of the thyroid gland. Additionally, it should be placed so that it is completely covered with the arm in the anatomic position. The subcutaneous skin flap from the axilla to the anterior neck area is dissected over the anterior surface of the pectoralis major muscle and clavicle. To develop sufficient working space without tension, the subcutaneous and subplatysmal flaps should be dissected up to level of the upper limit of thyroid gland and to the superior end of the incision. In addition, dissection should be carried to 2 cm inferior to the level of the sternal notch and to the lower edge of the incision. After the SCM muscle is exposed, the thyroid compartment is approached through the avascular space between the two heads of the SCM muscle and deep to the strap muscle. Dissection should continue until the contralateral side of the thyroid gland is exposed. The omohyoid muscle is fully mobilized and retracted ventrally and the clavicular head of the SCM muscle is dissected fully to the bottom of inner space so as not to block the surgeon’s view. To assure sufficient inner working space, all soft tissues and the anterior surface of the thyroid gland are completely detached from the dorsal part of the strap muscles. The external retractor (Chung’s retractor) is inserted through the skin incision to maintain the working space and placed between the thyroid gland and the strap muscles. Experience has shown that to achieve adequate working space, the height of incision entrance should be ≥4 cm and the space between the retractor blade and the anterior surface of the thyroid gland should be ≥1 cm.
Robotic Docking
The patient cart is placed on the side contralateral to the axillary incision. To avoid inter-arm collisions, axis alignment is important. The operative table should be positioned slightly oblique, and the center column of patient cart should be aligned with the long axis of the external retractor.
Two-Incision Method
Robot-assisted transaxillary thyroidectomy was initially performed using a two-incision technique. The second incision is made on the anterior chest wall on the side of the thyroid pathology, 2–4 cm superior and 6–8 cm medial to the nipple, and away from the sternum. Of the four robotic arms, three arms are inserted through the axillary incision and the remaining arm is inserted through the anterior chest wall. The 30° down dual-channel endoscope is placed on the central arm and introduced in a downward to upward direction. It should be in line with both the center column of the patient cart and the long axis of the external retractor. The 8-mm Harmonic curved shears and the 5-mm Maryland dissector are placed on both sides of the scope and introduced in an upward to downward direction. The external third joints of these robotic arms should form an inverted triangle shape. The ProGrasp forceps, on the anterior chest arm, is inserted toward the targeted area and is placed laterally to the sternal head of the sternocleidomastoid (SCM) muscle.
Single-Incision Method
After performing more than 700 cases of the two-incision technique, we transitioned to using a single axillary incision. All four robotic arms are inserted through the axillary incision. As mentioned above, the dual-channel endoscope is placed at the center of the incision, aligned with the axis of the external retractor. To prevent interference between the robotic arms, the ProGrasp forceps are inserted caudal to the endoscope and positioned at the ceiling of the working space. The tip of the ProGrasp forceps is slid fully into the working space, and its external third joint moves backward and works in a different plane than the other three robotic arms. The 5-mm Maryland dissector and the 5-mm Harmonic curved shears are both inserted at the lateral border of the incision. From the outside, the arms form an inverted triangle with the external third joint of the endoscope.
Thyroidectomy (Dissection)
The surgical principles of robotic thyroidectomy and conventional open thyroidectomy are the same. Optimal dissection planes can be obtained by traction and countertraction using both a Maryland dissector and ProGrasp forceps, and all dissections and vascular ligations are performed using the Harmonic curved shears. The dissection proceeds in a superior to inferior direction. The upper pole of the thyroid gland is drawn in a medio-inferior direction using the ProGrasp forceps, and the superior thyroid vessels are ligated individually using the Harmonic curved shears (Fig. 9.5a). All vessels are identified and ligated close to the thyroid gland to avoid injuring the external branch of the superior laryngeal nerve. The thyroid gland is carefully detached from the cricopharyngeal and cricothyroid muscles by repeated re-grasping, which leads to gradual dissection of thyroid tissue. The upper pole dissection is continued until the superior parathyroid gland is exposed and released (Fig. 9.5b). The superior parathyroid gland is carefully preserved by avoiding lateral thermal spread from the Harmonic curved shears during dissection. For inferior pole dissection, the thyroid gland is pulled in a superior-medial direction. Before performing a central compartment neck dissection (CCND), the ipsilateral RLN is identified near the common carotid artery. After identifying the RLN, the ipsilateral CCND is started at the lateral side of the central compartment and is carried to the sternal notch inferiorly (Fig. 9.5c). All the soft tissues are removed from the paratracheal and pretracheal areas. The central neck contents and the inferior pole of thyroid gland are pulled upward and the whole course of the RLN is traced distally and preserved. The inferior thyroid artery is divided close to the thyroid gland using the Harmonic curved shears. Care is needed to avoid direct or indirect thermal injury to the RLN. The thyroid gland is meticulously peeled off the trachea using the Harmonic curved shears. In cases of total thyroidectomy, a contralateral lobectomy is performed by subcapsular dissection. The contralateral dissection is performed in the same order as that described for the ipsilateral side. The contralateral upper pole is drawn in an inferomedial direction using the ProGrasp forceps. The superior thyroid vessels are ligated close to the thyroid gland with subcapsular dissection (Fig. 9.5d). After detaching the upper pole from the cricothyroid muscle and preserving the superior parathyroid gland, the inferior pole dissection is completed. At the inferior pole, the inferior parathyroid gland and the contralateral RLN are preserved by subcapsular dissection (Fig. 9.5e). The contralateral RLN usually runs parallel to the dissection plane and is safe with subscapular dissection. After the inferior pole dissection, the thyroid gland is retracted medially using the ProGrasp forceps, and the lateral portion of the thyroid gland is detached until Berry’s ligament is exposed. The thyroid gland is then retracted ventrally and the dissection proceeds in a medial-to-lateral direction, following the RLN until its insertion site (Fig. 9.5f). The specimen is extracted through the axillary incision, and a 3-mm closed suction drain is inserted into the surgical bed.
